Sub-Total: £0.00
Stuart No.9
£1,939.00 (ex. VAT)
Stuart No.9 Fully Machined Kit
96 in stock
Description
The Stuart No.9 is regarded by many as the most attractive engine in the Stuart range. The No.9 is typical of the large powerful Steam Engines installed in factories and mills to provide power.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71832 x 2 More Information
Drain Cocks 34-50-71961 x 2 More Information
Paint Set 32-50-72388 More Information
Optional Accessories, (Not Supplied In KIt)
Governor Machined 34-50-72185 More Information
As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.
Additional information
| Weight | 8000 g |
|---|
Related products
Contents
Cast Iron: Boxbed, soleplate, cylinder, valve chest and cover, front and rear cylinder covers, piston, connecting rod, flywheel.
Gunmetal: Slide valve, eccentric strap, connecting rod bearings, valve operating block, glands, crosshead, valve rod guide, crankshaft bearings.
Steel: Crankshaft, eccentric sheave, piston and valve rods, eccentric rod, all materials for valve gear.
Sundries: Detailed drawings, cylinder lagging, gaskets, piston rings, gland packing, fixings pack.
Specification
Length: 11 Inches.
Flywheel Diameter: 5 Inches.
Cylinder Bore: 1 1/2 Inches.
Cylinder Stroke: 1 1/2 Inches.