Sub-Total: £0.00
Stuart 10V
£623.00 (ex. VAT)
Stuart 10V Fully Machined Kit
9940 in stock
Description
The Stuart 10V has for many years been the most popular engine in our range. It is powerful enough to drive a 48 inch model steam boat.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 2 More Information
Drain Cocks 34-50-71960 x 2 More Information
Paint Set 32-50-72388 More Information
Book 36-50-72465 More Information
Optional Accessories, (Not Supplied In Kit)
Reverse Gear Castings 34-50-71188 More Information
No.10 Feed Pump Castings 34-50-71211 More Information
Alternative Disc Wheel 31-50-72446 More Information
As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.
Additional information
| Weight | 2500 g |
|---|
Related products
Contents
Cast Iron: Boxbed, soleplate, standard, cylinder, valve chest and cover, top and bottom cylinder covers, flywheel.
Brass: Slide valve, piston, connecting rod, eccentric rod, valve operating block, glands, crosshead, crankshaft bearings.
Steel: Crankshaft, crankwebbs, eccentric sheave, crosshead pin, piston and valve rods.
Sundries: Detailed drawings, gaskets, cylinder lagging, gland packing, fixings pack.
Specification
Height: 6 Inches.
Flywheel Dia.: 3 Inches Diameter.
Bore: 3/4 Inch.
Stroke: 3/4 Inch.