Subtotal: £3,414.00
Stuart Beam
£1,707.00 (ex. VAT)
Stuart Beam Fully Machined Kit
9965 in stock
Description
The Stuart Beam is a relatively simple engine to construct. The use of Watts parallel motion makes this engine fascinating to watch, particularly at slow speeds.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 4 More Information
Drain Cocks 34-50-71960 x 2 More Information
Piant Set 32-50-72388 More Information
Book 36-50-72467 More Information
Optional Accessories, (Not Supplied In Kit)
Governor Machined 34-50-72182 More Information
As with all Stuart Models machined kits the Stuart Beam is supplied complete with a hand numbered certificate of authentication.
Additional information
Weight | 10000 g |
---|
Contents
Cast Iron: Bedplate, column, beam, pedestal, pulley, crank, cylinder, valve chest and cover, top and bottom cylinder covers, piston, flywheel.
Brass: Slide valve, eccentric strap, valve opperating block, glands, conrod bush, crankshaft bearings, beam bearings, entablature bearings, valve gear bearings.
Steel: Crankshaft, connecting rod, eccentric sheave, eccentric rod, clevis, crankpin, beam shaft, entablatures,piston and valve rods, valve gear and parallel motion.
Sundries: Detailed drawings, gaskets, viton “O” ring, gland packing, fixing pack.
Specification
Length: 13 Inches.
Flywheel Diameter: 7 Inches Diameter.
Bore: 1 Inch Diameter.
Stroke: 2 Inches.