Sub-Total: £0.00
Stuart Twin Victoria
£2,765.00 (ex. VAT)
Stuart Twin Victoria Fully Machined Kit
9979 in stock
Description
The Twin Victoria is essentially two Stuart Victorias running side by side. This makes for a very impressive model which will be the center piece of any collection.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 6 More Information
Finished Cylinder Pipework Set 34-50-71428 More Information
Paint Set 32-50-72388 More Information
Book 36-50-72462 More Information
Optional Accessories, (Not Supllied In Kit)
Governor Machined 34-50-72184 More Information
Oak Plinth 99-50-PlinthT/V More Information
As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.
Additional information
| Weight | 12000 g |
|---|
Related products
Contents
Cast Iron: Baseplates, cranks, cylinders, valve chests and covers, front and rear cylinder covers, pistons, flywheel.
Brass: Slide valves, eccentric straps, valve operating blocks, glands, conrod bushes, crossheads, crankshaft bearings.
Steel: Crankshaft, connecting rods, eccentric sheaves, eccentric rods, clevises, crankpins, piston and valve rods, all materials for valve gear and crosshead guides.
Sundries: Detailed drawings, gaskets, viton O rings, gland packing, fixings pack.
Specification
Length: 15 1/2 Inches.
Flywheel Diameter: 7 Inches Diameter.
Bore: 1 Inch Diameter.
Stroke: 2 Inches.