Stuart Half Beam Unmachined
£398.00 (ex. VAT)
Stuart Half Beam Engine Set of Unmachined Castings, Materials, Fixings and Drawings.
9924 in stock
Description
The Stuart Half Beam is a recent addition to our range. Based on the Stuart Beam this engine is relatively slow moving with the advantage of only requiring a small boiler to run.
Under steam the intricate movement of the valve gear combined with the elegant rocking of the beam make this engine almost mesmerizing to watch.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 2 More Information
Drain Cocks 34-50-71960 x 2 More Information
Paint Set 32-50-72388 More Information
Optional Accessories, (Not Supplied In KIt)
Oak Plinth 99-50-PlinthH/B More Information
Alternative Piston Rings x 2 32-50-72400 More Information
Please remember our sets of castings require the use of a lathe and milling machine to turn them into a working steam engine.
Additional information
Weight | 8000 g |
---|
Contents
Cast Iron: Baseplate, beam, beam support, A frames, pedestal, pulley, crank, cylinder, valve chest and cover, top and bottom cylinder covers, piston, flywheel.
Brass: Slide valve, eccentric strap, valve operating block, glands, conrod bush, beam pivot support, crankshaft bearings, beam support bearings, valve gear bearings.
Steel: Crankshaft, connecting rod, eccentric sheave, eccentric rod, clevis, crankpin, piston and valve rods, all materials for valve gear and beam pivot.
Sundries: Detailed drawings, gaskets, viton O ring, gland packing, fixings pack.
Specification
Length: 11 3/4 Inches.
Flywheel Diameter: 7 Inches.
Cylinder Bore: 1 Inch Diameter.
Cylinder Stroke: 2 Inches.