Stuart Victoria Unmachined

£398.00 (ex. VAT)

Stuart Victoria Set of Unmachined Castings, Materials, Fixings and Drawings.

9834 in stock

Part No: 34-50-71419 Category:

Description

The Stuart Victoria follows closely the design of low pressure horizontal engines used throughout the nineteenth century, to provide power in workshops and factories. The large flywheel allows the engine to run smoothly at low speeds where the long elegant stroke can be appreciated.

To assist the beginner the book “Building The Victoria” is available. It describes in detail the machining of all the components, and is full of advice for the more challenging operations.


Recommended Accessories, (Not Supplied In Kit)

Oil Cups 34-50-71831 x 4 More Information

Paint Set 32-50-72388 More Information

Book 36-50-72462 More Information


Optional Accessories, (Not Supllied In Kit)

Governor Castings 34-50-71181 More Information

Spring belt (for governor) 32-50-71394 More Information

Oak Plinth 99-50-PlinthV More Information

Alternative Piston Rings x 2 32-50-72400 More Information

Please remember our sets of castings require the use of a lathe and milling machine to turn them into a working steam engine.

Additional information

Weight 7000 g

Contents

Cast Iron: Baseplate, pedestal, pulley, crank, cylinder, valve chest and cover, front and rear cylinder covers, piston, flywheel.

Brass: Slide valve, eccentric strap, valve operating block, glands, conrod bush, crossheads, crankshaft bearings.

Steel: Crankshaft, connecting rod, eccentric sheave, eccentric rod, clevis, crankpin, piston and valve rods, all materials for valve gear and crosshead guides.

Sundries: Detailed drawings, gaskets, viton O ring, gland packing, fixings pack

Specification

Length: 15 1/2 Inches.

Flywheel Diameter: 7 Inches.

Cylinder Bore: 1 Inch Diameter.

Cylinder Stroke: 2 Inches.