Subtotal: £124.00
Stuart Victoria Unmachined
£398.00 (ex. VAT)
Stuart Victoria Set of Unmachined Castings, Materials, Fixings and Drawings.
9831 in stock
Description
The Stuart Victoria follows closely the design of low pressure horizontal engines used throughout the nineteenth century, to provide power in workshops and factories. The large flywheel allows the engine to run smoothly at low speeds where the long elegant stroke can be appreciated.
To assist the beginner the book “Building The Victoria” is available. It describes in detail the machining of all the components, and is full of advice for the more challenging operations.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 4 More Information
Paint Set 32-50-72388 More Information
Book 36-50-72462 More Information
Optional Accessories, (Not Supllied In Kit)
Governor Castings 34-50-71181 More Information
Spring belt (for governor) 32-50-71394 More Information
Oak Plinth 99-50-PlinthV More Information
Alternative Piston Rings x 2 32-50-72400 More Information
Please remember our sets of castings require the use of a lathe and milling machine to turn them into a working steam engine.
Additional information
Weight | 7000 g |
---|
Contents
Cast Iron: Baseplate, pedestal, pulley, crank, cylinder, valve chest and cover, front and rear cylinder covers, piston, flywheel.
Brass: Slide valve, eccentric strap, valve operating block, glands, conrod bush, crossheads, crankshaft bearings.
Steel: Crankshaft, connecting rod, eccentric sheave, eccentric rod, clevis, crankpin, piston and valve rods, all materials for valve gear and crosshead guides.
Sundries: Detailed drawings, gaskets, viton O ring, gland packing, fixings pack
Specification
Length: 15 1/2 Inches.
Flywheel Diameter: 7 Inches.
Cylinder Bore: 1 Inch Diameter.
Cylinder Stroke: 2 Inches.