Sub-Total: £0.00
Stuart S50
£623.00 (ex. VAT)
Stuart S50 Fully Machined Kit
9946 in stock
Description
The Stuart S50 is an elegant model ‘Mill Engine’ of the type used to power small factories in the north of England during the mid-nineteenth century.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 4 More Information
Paint Set 32-50-72388 More Information
As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.
Additional information
| Weight | 3000 g |
|---|
Related products
Contents
Cast Iron: Soleplate, cylinder, valve chest and cover, front and rear cylinder covers, flywheel.
Brass: Slide valve, piston, eccentric strap, valve operating block, glands, crosshead.
Steel: Crankshaft, crankwebb, connecting rod, eccentric sheave, eccentric rod, distance pieces, slide bars, crankpin, piston and valve rods.
Sundries: Detailed drawings, gaskets, fibre washer, cylinder lagging, gland packing, fixings pack.
Specification
Length: 8 1/2 inches.
Flywheel Diameter: 3 inches.
Bore: 5/8 inch.
Stroke: 1 1/4 inches.