Stuart D10
£1,114.00 (ex. VAT)
Stuart D10 Fully Machined Kit
9964 in stock
Description
The Stuart D10 is well suited to all kinds of stationary and marine work, being able to reach speeds of up to 2000 rpm.
This model must be seen to be fully appreciated. It is both elegant and well designed in addition to being thoroughly practical.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supllied In Kit)
Oil Cups 34-50-71831 x 3 More Information
Drain Cocks 34-50-71960 x 4 More Information
Finished Cylinder Pipework 34-50-71212 More Information
Paint Set 32-50-72388 More Information
Book 36-50-72465 More Information
Optional Accessories, (Not Supplied In Kit)
Reverse Gear Castings 34-50-71210 More Information
No.10 Feed Pump Castings 34-50-71211 More Information
Alternative Disc Wheel 31-50-72446 More Information
As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.
Additional information
Weight | 3000 g |
---|
Contents
Cast Iron: Boxbed, soleplate, standards, cylinders, valve chests and covers, top and bottom cylinder covers, flywheel.
Brass: Slide valves, pistons, connecting rods, eccentric rods, valve operating blocks, glands, crossheads, crankshaft bearings.
Steel: Crankshaft, crankwebbs, eccentric sheaves, crosshead pins, piston and valve rods.
Sundries: Detailed drawings, gaskets, cylinder lagging, gland packing, fixings pack.
Specification
Height: 6 Inches.
Discwheel Diameter: 1 5/8 inch Diameter
Bore: 3/4 Inch