Stuart 10H

£593.00 (ex. VAT)

Stuart 10H Fully Machined Kit

9980 in stock

Part No: 34-50-71196 Machined Kit Category:

Description

The Stuart 10H is a development from the popular 10V Engine. It is more than capable of ‘doing work’ and can easily power a small dynamo or pump.

This small horizontal engine offers both power when run at high speed and visual interest when operated at slow crankshaft speeds.

The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.


Recommended Accessories, (Not Supplied In Kit)

Oil Cups 34-50-71831 x 2  More Information

Drain Cocks 34-50-71960 x 2  More Information

Paint Set 32-50-72388     More Information

Book 36-50-72465 More Information

As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.

Additional information

Weight 3000 g

Contents

Cast Iron: Boxbed, soleplate, cylinder, valve chest and cover, top and bottom cylinder covers, flywheel.

Brass: Slide valve, piston, connecting rod, eccentric rod, valve operating block, glands, crosshead, crankshaft bearings.

Steel: Crankshaft, crankwebbs, eccentric sheave, crosshead pin, piston and valve rods.

Sundries: Detailed drawings, gaskets, cylinder lagging, gland packing, fixings pack.

Specification

Length: 6 Inches.

Flywheel Diameter: 3 Inch Diameter.

Bore: 3/4 Inch.

Stroke: 3/4 Inch.