Sub-Total: £0.00
Stuart Victoria
£1,707.00 (ex. VAT)
Stuart Victoria Fully Machined Kit
9991 in stock
Description
The Stuart Victoria follows closely the design of low pressure horizontal engines used throughout the nineteenth century, to provide power in workshops and factories. The large flywheel allows the engine to run smoothly at low speeds where the long elegant stroke can be appreciated.
The kit comes with all the components turned, milled, drilled and threaded, allowing you to finish the model with no more than a set of spanners, a screwdriver, a selection of small files and a paint brush.
Recommended Accessories, (Not Supplied In Kit)
Oil Cups 34-50-71831 x 4 More Information
Paint Set 32-50-72388 More Information
Book 36-50-72462 More Information
Optional Accessories, (Not Supllied In Kit)
Governor Machined 34-50-72183 More Information
Oak Plinth 99-50-PlinthV More Information
As with all Stuart Models machined kits it is supplied complete with a hand numbered certificate of authentication.
Additional information
| Weight | 7000 g |
|---|
Related products
Contents
Cast Iron: Baseplate, pedestal, pulley, crank, cylinder, valve chest and cover, front and rear cylinder covers, piston, flywheel.
Brass: Slide valve, eccentric strap, valve operating block, glands, conrod bush, crossheads, crankshaft bearings.
Steel: Crankshaft, connecting rod, eccentric sheave, eccentric rod, clevis, crankpin, piston and valve rods, all materials for valve gear and crosshead guides.
Sundries: Detailed drawings, gaskets, viton O ring, gland packing, fixings pack.
Specification
Length: 15 1/2 Inches.
Flywheel Diameter: 7 Inches Diameter
Bore: 1 Inch Diameter
Stroke: 2 Inches